Category: Main > Commercial - Dealer Only > Rotators

EMOTATOR EV-700R & 1105 DS7R EL-AZ COMBO  - $2,300 Listing ID: 30109



Classified Info

Listing Began: May 30 18:30
Number of Times Viewed: 484
  • 2021-05-B01.jpg
  • 2021-05-B1.jpg
  • 2021-05-C01.jpg
  • 2021-05-C04.jpg
  • 2021-05-B02.jpg
  • 2021-05-B04.jpg
  • 2021-05-B09.jpg
  • 2021-05-B11.jpg
  • 2021-05-B12.jpg
  • 2021-05-C06.jpg
  • 2021-05-C07.jpg
  • 2021-05-C08.jpg
  • 2021-05-C15.jpg
  • 2021-05-B13.jpg
  • 2021-05-B16.jpg
  • 2021-05-B18.jpg
  • 2021-05-B38.jpg
  • 2021-05-B41.jpg
  • NewDS-7R pcb001.jpg
  • EV700-1105 p06.jpg

Videos


Description

Seller's Comments and Description:

 Emotator EV-700R 24v AC EL Rotator Set

& Emotator 1105 DS7R Az 24v AC Rotator Set.

Includes MC1217 mast clamp, 4 x Plugs for control cables & IEC power leads, Revised manual, 6 core control cable sold separately cut to length.

Wind Area Az ..................... 2.5m Sq.

Wind Area El ...................... 2.0m Sq.

Rotation Torque Az ...........  8.0 Kg/m

Rotation Torque El ............. 14.0 Kg/m

Brake Torque Az ................ 100 Kg/m

Brake Torque El .................. 50 Kg/m

Mast Size ............................ 40 ~ 61mm. U-Bolt mast clamp

Horizontal Boom El .............40 ~ 50mm. U-Bolt clamping

Rotation Time Az ................ 75 second for 360 degree

Rotation Time El ................. 85 second for 180 degree

Control cable Az/El ..............2 x 6 core

Drive train.............................Reduction gear using all steel gears

Rotator Voltage Az/El ..........24vAC.

Controller Features..............Full circle direction display with LED
                                               illumination,
Mom & Lock direction
                                               switch, RS232 remote control. 

Rotator weight Az/El............12.0kg Combined including Mast Clamp

Controller Weight .................2.83 kg each

Warranty................................24 month

 

THE DS7R CONTROLLERS AZ & EL:-  Full circle display with LED illumination, momentary & lift to lock direction switch, All new PCB with RS232 Remote .

The Front Panel:- Has full direction display, single Left/Right  direction switch.   

The Back Panel:- Installed new 6 pin Cinch socket, Fused IEC 240v socket & earth bolt + meter calibration pot, chassis was re-zinc plated as well as the terminal cover plate.

On The Inside:- All NEW PCB With RS232 remote output (since the original EV-700X did not have RS232 remote) & 12v DC out to power the LED illuminated display, I installed an extra transformer to power the new PCB, Replaced the display drive belt, Refurbished the POT & display assembly, Fully re-wired. 

Re-assembled, fully tested & aligned with the rotator.

 

THE EV-700R EL ROTATOR:- Has a 24v AC motor & all steel gears.

Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.

Refurbished & upgraded the drive train, Replaced limit switches, Refurbished the POT.

All housing & boom clamps are original painted in very good condition. 

Replaced the original control cable plug/socket & cover with a new LTW 7 pin socket on a Stainless steel cover mounting plate & new 7 pin plug, fully re-wired.

Installed refurbished gear sub chassis into the upper housing, Installed new bearings with new grease, Installed & aligned the hollow axial, Reassembled the two housings.

 

THE 1105 AZ ROTATOR:- Has a 24v AC motor & all steel gears.

Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.

Installed new upgraded 12mm gear shafts into the lower gear plate, these new shafts were fixed in place to stop them from spinning in the plate. These new shaft have groves for Circlips so the two heavy top gears are kept off the faster moving lower gears keeping from being loader up. The upper gear plate was re-zinc plated.  

All housing & the mast clamp assembly have been Glass Bead Blasted by IMPACT GLASS BEAD Then etch primed followed by painting in Hammertone paint finish (to match the EV700 rotator). 

Replaced the original control cable plug/socket with a NEW 7 pin LTW socket/plugs, Replaced limit switches, Fully rewired.

Aligned & shimmed gears into there sub chassis then re-assembled into the refurbished housings with new bearings & new grease through out.

Re-aligned & calibrated with controller.

240v AC, 24 month warranty.

This unit is available for exchange. See details on my web site.
Contact Peter of Duoro Services on 0427 043 054 (NO SMS) or via the VK Classifieds embedded email service.


Details

Manufacturer Emotator & Duoro
Model EV-700R & 1105 DS7R
Condition of Item Excellent
Accessories Included Mast clamp, plugs for control cables, IEC power leads, revised manual
Postage / Freight Buyer Pays





Advertisement

<< Previous Next >>