Category: Main > Commercial - Dealer Only > Rotators

CDE/HyGain T2X (TailTwister). Basic Refurbishment.  - $450 Listing ID: 19348

Classified Info

Listing Began: Oct 7 12:45
Number of Times Viewed: 783
  • 01-06-001.jpg
  • 01-06-002.jpg
  • 01-06-003.jpg
  • 01-06-004.jpg
  • 01-06-006.jpg
  • 01-06-007.jpg
  • 01-06-009.jpg
  • 01-06-010.jpg
  • 01-06-011.jpg
  • 01-06-012.jpg
  • 01-06-013.jpg
  • 01-06-014.jpg
  • 01-06-015.jpg
  • 01-06-016.jpg
  • 01-06-017.jpg
  • 01-06-018.jpg
  • 01-06-021.jpg
  • 01-06-022.jpg
  • 01-06-023.jpg
  • 01-06-024.jpg


  • $80


Seller's Comments and Description:

Base Refurbishment & Service Rotator Set.
Wind Area.................1.8m Sq.
Rotation Torque........11.7 Kg/m.
Brake Torque............104 Kg/m.
Mast size...................50mm.
Rotation time............60 seconds 360 degrees.
Control cable.............8 core.
Rotator voltage..........24v AC.
Controller voltage.......110v AC (inc. 240v AC Stepdown transformer).
Shipping weight..........Approx. 18 kg

The CDE Controller:- Standard panel metered, 110v Ac input, includes 240vAC stepdown transformer.
NEEDES 8 core control cable.
This controller was part of a trade-in/exchange, hence why it has only had a basic refurbishment.
It has been cleaned & checked that all works properly.
The plastic casing has scratches & a burn hole from when someone put the casing on the wrong way & the illumination bulb melted it.
This controller has a 110v AC input & is supplied with the 240v stepdown transformer it came with, also tested & works, also cleaned + had a few labels added.

The CDE T2X Rotator:- Has a friction brake iside the motor + a solenoid activated brake wedge.
This controller was part of a trade-in/exchange, hence why it has only had a basic refurbishment.
Has been completely stripped down, cleaned then re-assembled bearing + new grease through out.
Plus I had to replace the faulty Limit Switch assembly (after I had assembled it), meaning I had to disassemble it to replace it with a new current version.
Since this rotator didn't have a mast clamp assembly I used one of my new Stainless steel replacement version & a set of used 'U' bolt set.
The housing are as I got it painted in off white which has chips & scratches etc.
Align & Calibrated with the controller.
NOTE: The POT in this rotator is 485 ohms (instead of 500 ohms), mening the alignment & calibration is out (I got it as best I could). It would have had the alignment issue from day one as it seems to be the original POT.
Includes Top mast clamp & hardware.
Contact Peter of Duoro Services on 0427 043 054.


Manufacturer CDE/HyGain
Model T2X
Condition of Item Good
Accessories Included Top Mast clamp & hardware + Manual copy
Postage / Freight Pickup Available


<< Previous Next >>